2. misc-audio
  3. 127036-18911

How do i tell if i have a failed tube in my preamp?

Today after firing up system I noticed a distortion from all three drivers on one channel. Next I went from turn table to cd.Same thing,so I tried moving /wiggling all cables. No help or any change whatsoever.Could this be a tube going out in my BAT pre? Can I get an answer without a tear down please.I have extra tubes .6922s I believe.Thanks,R.W.
128x128rickw062
rickw062's avatar
rickw062 OP
23 posts
 
Just changed cables from left to right on pre.Problem still in same channel.Now i have isolated it to left mono block amp. I guess I'll open it up and check the caps and grounds before sending out for sevice.It has had a slight hum for awhile but did not draw attention while playing.Hmm.R.W.
yogiboy's avatar
yogiboy
5,656 posts
 
Just to make sure try swapping the speakers.
czarivey
5,946 posts
 
tubes are just like drugs -- reach pinnacle for short period of time than go to withdrawal symptoms :-)

Post removed 
jmcgrogan2's avatar
jmcgrogan2
6,346 posts
 
not everyone can afford fancy DJ equipment. ;^)

More to discover