I have a long-term investigation into Cables at all interfaces within the home system.
The continuation of experiencing other Cables within my system, has over the past recent months, resulted in my exchanging RCA Phono Cables and has led to discovering a Power Cable as well.
Each of the New Selection for Cables have shown more valued presentation is on offer from these New Selections, that surpass previous Cables trialed and given a permanent place.
The process is based on prior experiences and the learning gathered through these experiences.
The Good Thing about these types of endeavours, is that there is not a great skill required, the swapping of Cables is quite straight forward, with only a simplistic discipline required to carry out the exchanges, in some cases only to turn the Volume Down and in other cases to Power Off prior to the exchange.
Tube Rolling is met with a similar discipline requirement, and anybody who has Tube Rolled and discovered a Tube that is a preference over another, will already have an ear with an attunement to detect an effect a Cable can have on a replay.
This time around the Cable Trials proved to be a little more time consuming, as the full impact of certain exchange at certain interfaces required an extended period of A/B comparisons.
At a Bespoke Built Valve DAC > CDT the New RCA Phono Cable Type that proved to have had the greatest impact and attraction, has been a D.U.C.C wire Cable.
When using this on a SUT > Valve Phonostage > Pre-Amp', the impact was less noticeable, but what was being detected proved over time to be the preferred presentation.
My OCC Silver DIN/RCA Phono Cable is now replaced with a Cable that has PC Triple C wire. It took a long time to finally settle on the Silver OCC Wire Cable, and the PC Triple C was an immediate exchange, there is no desire to experience the OCC Silver anymore.
I have also been using a PC Triple C Power Cable.
The New Power Cable has proved to be an interesting umbilical, as it has what can be described as very noticeable impact on devices with Topologies that are Solid State or SS/Valve Hybrid but not as noticeable on Point-to-Point Topologies, which are an all-Valve Design.
The PC Triple C Wire Power Cable when used on a Valve DAC has been very attractive, when used on the CDT, the impact has been to my assessment almost parity.
When used on a Valve Phonostage and Valve Power Amp, the impression made is less, but without doubt improved over other Cables used in past trials.
The PC Triple C Power Cable has been loaned and used on a SS DAC to very good effect and also used on a Valve Hybrid CDP to very good effect.
A friend who is a designer and producer of a SS Phonostage has had my PC Triple C Wire Power Cable on long-term loan, following the good impression it has made.
The follow up to the loan was a gathering of Cables to be used in comparisons.
My Cable is a Nanotech, Furutech and Acoustic Revive PC Triple C Wire Power Cables as well a ferw other loaned Cables were put to trial.
The return report was quite interesting, as the Cable, which was selected, was a PC Triple C Wire Cable, but the one that was the most affordable.
I have made the selected Cable Known in the Link.
At the asking Price, I strongly recommend buying in a Length and terminating it onto Copper Pinned Plugs to produce one cable and using it on different devices in the system.