2. speakers
  3. 188737-976

How important is the efficiency of a speaker to you?

I went to an audio meeting recently and heard a couple of good sounding speakers. These speakers were not inexpensive and were well built. Problem is that they also require a very large ss amp upstream to drive them. Something that can push a lot of current, which pretty much rules out most low-mid ( maybe even high) powered tube amps. When I mentioned this to the person doing the demo, i was basically belittled, as he felt that the efficiency of a speaker is pretty much irrelevant ( well he would, as he is trying to sell these speakers). The speaker line is fairly well known to drop down to a very low impedance level in the bass regions. This requires an amp that is going to be $$$, as it has to not be bothered by the lowest impedances.

Personally, if I cannot make a speaker work with most tube amps on the market, or am forced to dig deeply into the pocketbook to own a huge ss amp upstream, this is a MAJOR negative to me with regards to the speaker in question ( whichever speaker that may be). So much so, that I will not entertain this design, regardless of SQ.

Your thoughts?

128x128daveyf
Post removed 
deep_333
1,446 posts
 

The very good high efficiency speakers also require a serious amp, they can still be difficult loads. Flea watt amps are dumb for any kind of speaker, high efficiency or not. Nothing about the flea watt amp guarantees that it is the best design for the first watt or fractions of it. In fact, a lot of them are garbage.

shanesrain
89 posts
 

Maybe some horns and colored cables might help. 

czarivey
5,946 posts
 

I benefit from speakers being quiet when on standby so I'd stay away from very efficient ones. Need to be between middle and low for that matter. Impedance stability is somewhat more important than efficiency especially If I want to use tube amp. For me performance matters and if I can figure out how to make it sound best, it means the speaker gets my attention for what it's worth. Ima garage sale junkie rat sneaking for lonely grammas to sell audio for cheap so spending not much either. If I note GOOD DEAL from any of the situations I'm trying to take advantage from, I wouldn't really care about neither efficiency nor impedance stability.

shanesrain
89 posts
 

A little off subject, but still might pertain. I drive big ss monos and noticed when the speakers were pretty close they seemed to start to cancel each other out. Maybe think spacing and sort of a sound hall, like the opposite of a bass trap. Can’t remember but bose may hsve had engineering that semi included something similar, not positve. Hard to remeber 25 years ago. Lol you might also be able to compromise and look for a/b systems.

More to discover