how should i move forward...blu-ray etc...?

Original post states Casanova, not Casablanca processor.. Isn't the Casanova model slightly different than the Casablanca on which it's based? Unless I read their website incorrectly, it looked to me like the Casanova has analog ins, "two pair analog L/R, plus one pair rear L/R, a center and sub... Of course this may have been an optional card which your particular unit lacks..

guys thanks for the discussion first of all!

mine is configured as i wrote...here is how the manual reads describeing that portion of the rear panel layout:

analog input card. six stereo rca inputs are provided for any line level analog aoutput device such as vcr, laserdisc, cd and dat players, phono preamp, eternal d/a converters, tape deck, am fm tuner etc. there is one pair of analog tape outs for recording purposes and one pair to route to another area (zone 2). the zone 2 output is controlled seperatley from the main analog output levels.

goes on about video input card and digital input card...

i also emailed theta this morning to see what they suggest...i will post what they say as well..

great discussion so far!

oh and yes, it is a casanova, not casablanca but sounds like the same configuration...

if you go to theta's site and library, product manuals, casanova, owners manual pdf page 16 shows the exact rear panel layout i have.

02-09-09: Chadnliz
Why cant it pass the signal from an internal Blu Ray decoder?

Because it doesn't have an analog 5.1 or 7.1 channel input. You can only connect a coax or Toslink digital link, or an analog stereo pair from a new Blu-ray player with internal decoding to the Theta Casablanca.

02-09-09: Richard_stacy
if you go to theta's site and library, product manuals, casanova, owners manual pdf page 16 shows the exact rear panel layout i have.

I did that, though I found the back panel diagram on page 7. At any rate, there is no multi-channel analog input and no HDMI input, so there's no way to get a lossless surround signal from a Blu-ray player into your Casablanca.

To illustrate what I'm talking about, look at the back panel of an Outlaw 990 AV Pre/pro here. Just to the right of the eight XLR inputs are two sets of color-coded RCA jacks, delineated by two white rectangles. The upper rectangle has 9 RCAs and is labeled "PREAmp Out," Your Casanova has an equivalent 5.1 channel output that's sent on to your amplifier(s).

The lower rectangle has 8 RCAs and is labeled at the bottom, "7.1 AUDIO IN." The 8 jacks are L, C, R, LS, RS, LRS, RRS, and Subwoofer. This 7.1 "Audio In" grouping (or at least a 5.1 Audio In grouping as many pre/pros and AV receivers have) is what you need at a bare minimum to get the lossless surround signals off an appropriately equipped Blu-ray player.

I have a Boston Acoustics AVP7, which is based on the same pre/pro as this Outlaw, and I use its 7.1 analog inputs this way to extract an uncompressed 5.1 surround signal from my SACD/DVD-A player with internal decoding. When used this way, the pre/pro simply functions as an 8-channel line stage.