Townshend Podiums, Pods, Platforms, and Bars: 3Hz.
How to isolate turntable from footstep shake or vibration
Even while the Oracle turnable that I use has a built-in springs suspension by design there is a low or even sub-low frequency boom every time someone walks in a room. This becomes really bad with the subwoofer’s volume set high as the low frequency footsteps make straight to subwoofer where they are amplified shaking everything around. It seems the cartridge is picking up the footsteps very efficiently as even a lightest foot down becomes audioable. What can be done to attempt to isolate the turntable from the low frequency vibrations? Interesting, that the lower the volume of the subwoofer, the less the footstep shake is evident and with the subwoofer turned off it is a barely a problem at all.
- ...
- 154 posts total
As others have stated, adding springs under a table having a spring suspension is a very bad idea (imagine a car having two sets of springs for each wheel!)They’re called helper springs. https://www.tarett.com/items/996-997-991-products/996-997-991-suspension/996-997-991-shocks~springs/... One way to consider going is to install Townshend Seismic Pods under not the base of the Oracle, but in place of the stock springs, with the Pods resting on the shelf, not the Oracle’s base. Good idea. Which is why I said: The most cost-effective answer will be if the Oracle feet can be replaced with Townshend Pods. |
At AXPONA I visited Butcher Block Acoustics. Very nice turntable platforms. But I may be incorrect here, but I am not certain there is a substantial difference between them and one of the thickest maple cutting boards you can find on eBay for a lot less. So I put my VPI Prime Signature on top of one of those thick maple cutting boards. Never an issue. Done. |
My turntable is neither shelf wall mounted or resting on a bedrock type of base. My table is an older one with no built in springs or other dampening devices. My house is over 100 years old, second floor, and moves slightly with season changes. I use multiple subs. Never have experienced a degradation in sound with these conditions but wondered if better isolation from vibrations would produce any improvement and, if so, would I notice it? In one of my previous posts I asked what could be done to isolate the table from unwanted vibrations. Thanks to millercarbon for his input. He recommended springs under the table. So, I ordered some Nobsound springs (since they're not very expensive). Even though I don't have any romping kids stomping on the floor I did notice a slight improvement in sound. MC also recommended Townshend pods which do the job even better but given their expense I decided to, at least, try the Nobsound first. So many factors in vibration control. Good luck in your quest. |
- 154 posts total