2. amps-preamps
  3. 1190323342

Ideal Volume level

I've heard that preamps work best when the volume is set higher, and also that if you turn the volume past 12 o'clock you will destroy something...

This last comment seems to be too general, since the gain of the preamp will have a lot to do with this.

Here's why I am asking; most of the preamps I've owned had a gain of 20db, and the volume knob seldom reached the 10 o'clock position. Now I have a preamp with a gain of 11.5 db, and with some recordings I find myself listening at 12'oclock or a bit higher. Everything sound fine, no distortion at all, and the amp is far from clipping (I think). But, should I be concerned???

Here's the gear in case it helps:
Pre: Audio research SP16L with 11.5 db gain
Amp: Belles 350a ref with input sensitivity of 1.98V (500 WPC at 4 ohms)
Speakers: 4 ohms and 86DB
CDP puts out 0-2.2 V

Thanks for helping :)
htrookie
aball
2,016 posts
 
No, there is no problem - other than a psychological one. :) Just turn it up and enjoy the music.

Incidentally, it is true that many volume controls have better channel separation at the top end of their range so you might even be better off with a low gain preamp!

Arthur
htrookie OP
12 posts
 
Thanks Arthur; I just needed someone to say that :)
mlsstl
1,435 posts
 
Actually, the issue isn't channel separation in a volume control but rather tracking between the left and right channels. Mass production potentiometers tend to track more unevenly at lower settings. If your knob runs from 7 o'clock (vol all the way down) to 5 o'clock (vol all the way up), knob settings at 8 or 9 o'clock will probably have more imbalance in volume between left and right than an 11 o'clock or higher setting.

Many high end preamps use higher precision pots that help eliminate this problem, but you'll get a ability to control your volume more precisely if your typical listing settings are in the middle to upper range of the knob.

As long as you are not overdriving things (and you will hear distortion or an unreasonable volume if you are) there is no problem in having a volume knob set too high.
sugarbrie
3,854 posts
 
There is no magic "o clock". All volume circuits would have to be identical in all gear. Actually, everyone would have to have identical systems.

At what volume your speakers perform best is a more likely determinant.

Same for your amplifier's output.
More to discover