Influence of DC offset on bias

My above post would be for tube amps in general. I just noticed a past thread of yours referring to SS amps.

I'm referring strictly to SS. Amp has both offset and bias pots. I understand anything up to 50mv offset on each channel is acceptable, 0 being ideal. However, the best I can get is 16mv on the left, 26mv on the right. Bias set at 150ma on each channel. My question is, does the stilted offset skew the bias adjustment? I could just change up the left channel offset to match the right, but not all SS amps have offset pots. I have others with dc servo control and still others with discreet components for the offset but they are never identical on both channels either. So I guess what I want to know is should there be a bias compensation on either channel to accommodate the difference in offset?

Are you sure that you can play around with bias adjustment in SS amp?
In most of the SS cases I would strongly recommend not to adjust.

The pots are there for that very purpose. Channel balance depends on quiescent current being equal in both channels. But my question addresses exactly that issue. Must it be equal or adjusted relative to offset for each channel in order to achieve an equal end result at the speakers?

I rescind my post. It's in error for the purpose of this thread.