Is Solid State Preamp and Tube Amp A Good Combo?

I ran a klyne 6lx3p with vtl225 monoblocks and cary slam 100's driving dunlavy sc3's and soundlab m2's;I was very happy with the results.
I was a solid state person and once I tried tubes never went back;it is a very worthly experience;only you will know if you like or dislike it;and you can always resell the pieces if you choose to.
There are a lot of great users on this forum with excellant advice and experiences;a ton more than me.
I have always received excellant advice here and even get to exchange ideas and questions with some of the design engineers and makers of excellant gear.
Enjoy the quest!!!!

Yes, you'll read a lot of posts about using a tube preamp with a sand amp. No reason not to do it the other way round unless you really can't deal with the heat of the output tubes in you listening room. Everything depends on how the gear sounds together.

I use a Klyne SK-5A solid-state preamp with a pair of Audio Space Nova M34 monoblocks.

I used to have McCormack Micro Line Drive hooked up with VTL MB100. I loved this combo. IMHO you'll get a large dynamic headroom vs. tube pre and SS amp due to the large out/input impedance difference.

I agree with all said by the so far majority here. I will add ss to tube ... less fuzz on the peach ... more dynamics. But as one said it is all in the the total of the entire system ... down to wire matching for sound and .... of course somewhat your taste and ears.

I'm using a Rowland Capri linestage with Melody 300B SET amps and it works beautifully! I needed a pre that could be left on all the time, but couldn't give up the sound of tubes...result has been excellent! Not quite up to my Atma-Sphere / Atma-Sphere setup in a different room/house, but quite satisfying, nonetheless. Of course that setup was almost 8 times more expensive too!!

If your speakers are a decent match with the amp, it will work well!!