JMW9 setup tracking problems... need help


Hi,
After almost 20 years I decided to return to analog. Looking for a good TT, found here in Audiogon a VPI Super scoutmaster with JMW9 arm in perfect condition and decide to buy it. I follow all the setup procedure: first level the turntable; then lower to arm until is parallel with the plate (to get that I had to lower the arm up to its lowest point); use an arm load meter to set up the traking force(I use a Denon 103R cartridge at 2.88g; little bit high of its higher set up of 2.8g); and rotate the counterweight to get perfect lateral balance; and finally I use the alignment jig to setup the perfect placement of the cartridge in the headshell. Everything looks OK but each time that I try to play a record the stylus runs across the vinyl and jumps half a song or more and sounds are sometimes (not always) intermitent. In inner grooves stylus track better b ut not perfect.
Maybe this is a silly question but dont know what else to try (I recheck everyhting and all looks ok) and VPI is not open until the 7th and will love to spend this holidays enjoying this grate TT. Thanks in advance
jorsan
Can't find in the VPI Industries page who represents them in my area (Miami, FL.) so if someone knows that information, please let me know. Thanks
I just redo all the setup and now is working (I must have done somehting wrong the first time but dont know what was); will try it today and hope will have no more issues. Thanks to all for your help and if I have more problems will post them here. Again, thanks for your interest and Happy 2009 !!
"....looks like the arm doesnt need it, the counterwheight is in the middle when I set up this cartridge."

The purpose of the added weight has naught to do with VTF, but with tweaking the arm resonance relative to the dynamic compliance of the cart suspension. Since the DL103 is a relatively low compliance cart (though, as I said, not as low as it's specs makes it appear), you may see sonic upgrades by adding the weight (and readjusting the arm for correct VTF). At this point, however, if you've got the rig running, just enjoy some music. You'll want to establish a listening reference point before you make any changes, or do any experimenting. Though, were I you, I'd lower that VTF to 2.5 at some early point.

If you do want to experiment with adding weight to the headshell, and you've got an electronic scale, I'd suggest weighing out a blob of Blu-Tac and attaching it to the top of the headshell. That way, you don't have to remove/readjust the cart while you're experimenting. If you like the change, you can add the VPI weight for Handsome Good Looks.

And btw, congratulations on getting 'er going.