Krell Power Consumption


Hi,

I'm a bit new to ultra high end. I'm considering a Krell Evolution 402. One thing that jumps out at me is the power consumption in standby. The manual says it draws over 300 watts in stand by and recommends that you leave it on all the time. 300 watts 24/7. Good grief. Is this bogus or just the price you pay for a serious amplifier?

thanks for any advise.
wrf
"I'd be curious to know how PF and regulation relate. "

Hello Magfan: It is that PF correction, as I wrote above, remove ripples and other "terrible" artifacts which produce odd-order ear-piearcing harmonic distortions. Please see below from Jeff Rowland web site:

"External JRDG PC1 is active Power Factor Correction (PFC) units. These devices preconvert the AC from the mains to a steady 384V DC current fed into the monos through a banck of intermediate charge capacitors and make the "501" much less sensitive to AC noise and fluctuations. They also keep the 501s internal caps optimilly charged avoiding AC induced ripples. PC1s should yield even larger authority to the "501"s and will give them a lot more subtlety and nuance"

mote "avoiding AC induced ripples ".

Effects of ripples and other things on distortions are desribed in Simon Thacher of Spectron paper:
http://www.enjoythemusic.com/magazine/manufacture/0708/index.html

All The Best
I guess we're talking about 2 different things.
Power Factor is simply the phase relationship between voltage and current in an AC signal...be it the power coming in or the audio to your speakers.

The JRDG approach is a complete power supply and IMO, the PF is tossed in as an advert blurb. This does NOT mean the power supply does not work as advertised. Just that PFC doesn't have much to do with it.

The article you linked is good....as far as it goes. In the discussion of REAL speaker loads, NO mention is made of phase angle. At a phase angle of 45 degrees....not uncommon, the delivered power will drop by about 30%. This represents an additional load to the amp. Now, I realize the numbers were used for illustration purposes only, but that is the real effect of phase on deliverable power.
The same is true of the power supply as it plugs into the wall. I'm no expert at this, but if your power supply has a 100va transformer and a PF of say.....0.8, you won't be able to get the full power out of the transformer..it'll saturate.

Does the JRDG amp deliver? You bet. Does PF have much to do with the rest of the claims? I'm a little leery.
FYI, I did go from the FPB Cx amps to the Evo stuff....drumroll........keep the FPB stuff if you have it! Krell is now obsolete. Moment of silence please:O(
Interesting topic gents,

I have used and listen to Krell stuff over the years and while powerful tanks, i was never really fond of the
sonic's. Recently i was presented with the opportunity via a good friend to play around with a Krell he had and one thing lead to another and we ended up servicing and modding this unit (KSA200)and would like to pass on my most recent experience and address a few concerns mentioned here.

Firstly due to the high class-A bias most Krell products operate at there idle current will always be excessive and of course nothing like CLass-D stuff...

1. There is no necessity to leave any high bias Krell product running 24/7, 1 hr before listening is sufficient IMO, there high quiescent current is sufficient for the amplifier to reach operating temps and a stable Bias.

2. Regardless of what the guys in print will say, leaving any amplifier that runs at such a high Bias/temperature running 24/7 will shorten the life of the components and lead to sound degradation over the years. Amps that are only 7 yrs old can have issues and of course this IMO lead's to that hard, cold , dry sound most associate krell's with, especially used Krell's.

The Krell in Mention KSA200..

The KSA200 was an amp in long service by my friend and over the years it has made 2 trips back to Krell ( enormous expense) for repairs. Of course this beast idled at 15 amps, YES 15amps and ran as hot as a stove.

On it's second trip back to Krell 2-3 years a go my friend decided to try Bel Canto mono bloc's and was immediately impressed and voiced to me that he will not want the Krell back in his system and upon it's return he would put it up for sale. His decision was later reinforced on the amps return as it's sound was promptly condemned after a thorough listening session comparing the 2, to make matter's worst the Krell failed again a few months later..

The decision was then made, for us to take a look at the amplifier and see what could be done. On examination we found that Krell was only replacing the broken parts and never attempted to fix the problems which by now were bad leaky caps all over the amplifier main boards. Long story short, we went through the whole amp , replaced all caps
(upgrade) except the PSU ( perfect when measured ).

We had reduced the Bias on start up as a safety precaution with the intent of re-biasing the amplifier back to class-a as to Krell specs and after the usual precautionary checks all seemed well, good power,sine wave /et al.
The suggestion was then made to try the amplifier at the lower a/ab bias ( since it speced well ) before going to full class-a Bias.

THE DIFFERENCE WAS ASTOUNDING .. much faster and dynamic than we had ever remembered this amplifier, the sound was so much better, the Bel cantos now did not stand a chance.

During the listening session a few thought the top end was better in full class-a , but all agreed that
1. Bass
2. Sound stage
3. Attack and Speed

was vastly improved with better tonality than before.

Anyway we took this behemoth back to the bench and adjusted it back to it's full class-a spec, plugged it in and ........ Yes.... a disaster!

The difference was staggering , dynamics lost, bass pulled back, dead , dead sound ..

Now my friend has a cool running KSA200 barely warm after hrs of listening,fantastic sound and many new Krell friends :) leaving many anti-Krell individuals ( myself included) blown away at the transition and how really good this amplifier sounds.

I have always felt when listening to high bias class-a amplifiers that they did not exhibit the rhythm and or pace of a good a/ab amplifier, always dead sounding to me by comparison, refined sound, Yes , but no music..

I would like to believe this is what most hear when switching to Class-D, but to my ears class-d is a bit Harsh sounding, yes definitely fast sounding and alive , but there is some crudeness there where a good a/ab amplifier does not exhibit that IMO.

Currently looking into modding and comparing a few other Krell models ( FPB series up next) to see if the mods were specific to this one model or will other Krell models benefit from cap upgrades and reduction of it's quiescent bias.

Stay tuned ..

regards