Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Al, as you might know, I am very non-technical, so I had to read what you wrote a few times. Is it correct to say that

A transformer replaces resistors as the means of attenuating the signal and provides some impedance matching help.

Buffers attenuate nothing, but creat ideal impedance matching.
Paul -- Yes, that is exactly correct IMO.

Although some might raise minor quibbles about the use of the word "ideal," because there will always be a limit to how severe a load a given buffer can handle without its performance degrading.

Best regards,
-- Al
Lstack, thanks for the write up on the Lightspeed Attenuator in a system that was not a prefect impedance match as this has never been done before. I have listened to it in the same situation and thought it was still better than listening to active pre's and other passives, and this is what I tell customers when they ask.
It's just not functioning at 100% of it's capabilities, so when you do manage to listen to it properly matched up you will only then realize it's full potential.
BTW there is no problem using it this way, no harm is done to anything.
Cheers George
Forget "ideal" - didn't mean to say that, but I think you know how I did mean it.
Fellow Lighspeed owners - The listening level that I use has my Lightspeed volume at about 8-9 o'clock as my 97dB efficient speakers don't require many watts to crank them up (I'm using an Art Audio PX25 SET amp with 6watts/ch. by the way).

Am I missing anything by not having the volume at a higher setting (11-1 o'clock for example)? Besides getting louder, will the sonics improve as I turn the volume up louder?

Thanks!