Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
No I have not tried it, but I have compared pure battery power to the standard supplied power supply, and the difference is subtle, you can't put your finger on it, that subtle that you forget which is on.

I posted this power supply as it looks impressive for the cost, and looks to be very very well made both in circuit and appearance for the money. And you get a bonus with it, a well regulated linear USB 5v supply.

But no I have not tried it, but you know what audiophiles are like, especially with power supplies and plug in tweaks that don't cost the earth.

http://www.ab-system.hk/index.php?route=product/product&path=73&product_id=64

Cheers George
Thank you George,I have just ordered one.
Compared to the walwart I've been using, this looks like a very well made piece for reasonable money.
I have been very pleased with the performance of the LSA as it is,this looks like it should improve things even more, and if so I'll be quite the happy camper.
It is nice to hear ones having success with a passive. I think it takes time and patience to adapt it to a system. This might be quite contrary to what one might think but I think I have found that the more neutral and clean sounding cables are(or I should say what I consider a neural and clean cable because I don't pretend to be a cable expert), the more warmth and fullness in a recording comes out(I am supposing that only if it is on the recording because the LSA doesn't add anything right?). At least that is kind of contrary to what I thought. When I say neutral I don't mean lean or edgier or brighter, I mean what I perceive as a cleaner signal. In fact is seams like the cleaner the signal (less distortion?) you have from source to speakers the better the passive's strengths show. I guess I am saying when a signal doesn't get as muddied up? Just my take but I thought I would share, it may help someone else.
Apparently, being perfectly content with the LSA and its wall wart isn't incompatible with ordering this new 'fancy' power supply :).

fyi: one can buy it off the bay so as to avoid having to register at yet another website.
Banquo363 that site takes Payapl, so you will also have it's buyer protection. And I believe their postage is reasonable, and you get to order the right voltage for you country as well.

Cheers George