http://www.gr-research.com/myths
Just in case anyone thought it was just one driver that exhibited the measured behavior of break in.
Just in case anyone thought it was just one driver that exhibited the measured behavior of break in.
Magico S5 vs KEF Blade 2 vs TAD Evo One vs YG Kipod II Sig w/pwr bass
http://www.gr-research.com/myths Just in case anyone thought it was just one driver that exhibited the measured behavior of break in. |
That larger room is what the Blade needs to sing. And man, they do. Like no other speaker I've heard, when they have the space around them is where they work best and have a remarkable ability to project the most defined soundstage I've ever heard. Depth and width of the soundstage is just uncanny. When I heard the Blade in a smaller room it just wasn't right, and that's where the Blade 2 did better. Both are a critical speaker in that if you have poor quality recordings, you'll know it. |
@csmgolf Good points! I agree with you. Yes these small changes which are usually attributed to spider compliance are well known. Should the spider dominate the in box designed response - probably not on a good design? So what seems not to be well understood is that an excellent driver and box design will be quite insensitive to spider compliance. A poor speaker and drive design will be sensitive to the spider compliance. It has a lot to do with the acoustic suspension (which dominates) and the power of the drive motor (magnet and coil diameter). 20 hours sounds about right for most of the break-in to have occurred on some drivers like the $30 one you referred to. I am confident Magico would use much higher spec and commensurately more expensive drivers. An analogy is towing a trailer. A large diesel truck with a poweful 5 liter motor is not going to be as sluggish towing a trailor as a small gasoline van. In this case the higher torque perfornance of the truck makes the impact of the trailer mass less influential. |
If you read the text, the test was conducted using 40 hertz test tone at a power level to achieve half of x-max. Playing a signal like that will break in the spider at a much greater rate than any music signal that any person would listen to. And still, all of those drivers were showing changes at 80 hours, though they were decreasing at every interval. How many hours of music playing would it take to achieve the same thing? I am not sure, but my guess would be significantly more than that. If you also read in the first link, the responses by the manufacturers state that this happens with all woofers. They make no exception, cheap or not. The Scanspeak 8545 is notorious for this very behavior. It is $175 per driver, so not exactly cheap and it is an excellent sounding driver. One of my current speakers is Meadowlark Shearwater Hot Rod, uses this driver and it sounds terrific within its limits. Every comment I have ever read on those speakers states a long break in time for that driver. It is not because the box is poorly designed. Bad assumption. Also note in the first link that the electrical Q changes throughout the course of the break in. Not just mechanical changes. Both manufacturers said that his measurements are what they see when they measure drivers. There are far too many people that experience the same thing to just dismiss it out of hand as their ears getting used to the sound or blaming it on poor design. |