Magnepan 3.7 Jumper Direction?

Thanks all so far. My attempt was a DIY disaster. Just not a handy kind of guy. However, FWIW, the jumpers I made of some Anticables worked out and are quite an improvement over the stock ones. Tried some plain 10 or 12 ga. solid copper house wire. Rolled off the top some. Meh.

Dpmolino, I also made some jumpers for my 3.7s out of Anticable wire. They were really pretty good, and were certainly better than those things Magnepan supplies. I had some Audio Magic Liquid Air jumpers custom made, and they were another step up from the anti cables. I also use Liquid Air speaker cables with my 3.7s.

I'm not a fan of AQ type 4. Moved away from them years ago. Way too much grain for my ears.

Cardas makes some jumpers specifically for the Magnepan speakers. I use a full set of these from crossovers to the speakers and all of the jumper points.

Best I have ever used. Expensive, but IMHO, worth every penny.

You can buy the complete set or just the jumpers. They all use the special "Maggie Pin" for the connections and fit perfectly.

http://www.dedicatedaudio.com/inc/sdetail/115/349

"Magnepan does NOT have 'bright harsh highs'. If you experience this with your Maggie ribbons, I suggest your electronics suck, and not the Maggies."

Then why does Magnepan give you the jumpers to begin with? The jumpers are not a 3rd party solution. This is how Magnepan deals with the problem. Call them and they'll tell you. You may not have to use them in your system because when you link active preamps, using them both at the same time, the result will very likely roll the top end off.

As far as my electronics goes, what pieces suck?