McIntosh MA5200


I haven't seen too much written about this integrated amp. Any opinions out there?
jimmymac
A German Hi Fi Mag. Stereoplay found 206WPC into 4 Ohm. McIntosh does not provide a 4Ohm measure.
And that is one the reasons why I did not buy this amp and went with my Marantz reference unit instead. Anyone know the reason why McIntosh does not give this model a 4 Ohm rating? Especially if it supposedly tested as such?
"Anyone know the reason why McIntosh does not give this model a 4 Ohm rating? Especially if it supposedly tested as such?"

My best guess would be that McIntosh is known to be one of those brands you turn to if you need something very powerful, kind of like a Bryston or Krell. 100 McIntosh watts should be comparable to just about any other brand. But that's just a guess on my part. I agree with you in that they should have listed a 4 ohm rating. It can't hurt them.
McIntosh uses auto transformers which makes the power output the same into 4,8 & 16 ohm speakers.
"06-05-15: Stereo5
McIntosh uses auto transformers which makes the power output the same into 4,8 & 16 ohm speakers."

That's true on most of their amps, but the MA5200 doesn't have them.

That may be the answer to your question Paraneer. Maybe they don't post anything other than 8 ohm's so the amp doesn't stand out as being different. I bet a lot of people assume like Stereo5, that their amps all have autoformers.
It always surprises me when people don't check the manufacturer's documentation that is available online at no cost. The manual for MA5200 clearly states in three places that the MA5200 is designed for speakers with an impedance rating of 8 ohms. The German magazine found exactly what would be expected for output into a 4 ohm load, but because Mc doesn't explicitly state output values into 4 or 2 ohms as they do for other products, the amp section likely becomes unstable those average loads. In short, it will work but will get hot and eventually distort the signal. Mc makes a terrific product line, but this is their entry-level integrated. Depending on the rest of your system, a different model might be a better choice. An excellent source for advice would be Audio Classics in Vestal NY. Highly recommended.

Good luck and happy listening!