Naim and Magnepan

Maggies 1.6's take oodles of power to "open them up". Some comments about lack of bass, are due to the fact that many people are under-powering them. Figure AT LEAST 250 wpc (4 ohm load, which is nice, as this is closer to a resistive and not an impedence load). I was pushing 500 wpc [RMS], and NEVER had a problem with anemic bass. The 1.6's take a long time to break in, as well!

It could be the other way around, ribbons are very fast. The Naim will need to drive very fast and somewhat difficult 4ohm load without loss of PRAT on their end. Some amps can not maintain under stress, you could take your amp to a maggie dealer if there is one near you.

Thanks guys.
Sogood51: Im looking at a used pair of 1.6s so a dealer demo is out.

Fatparrot: Look what I found!

http://www.positive-feedback.com/Issue3/nait5.htm
Read Victor's review. That little Nait got some set of balls! :^)
I've heard everything from people using SET amps as well as Fatparrots amp in driving Maggies. Im sure many variables are involved in just how much they need.

Thanks again guys

The Nait5 struggled with a ProAc Studio 125 (sounded thin with anemic bass). I've gotta believe that Maggies are a tougher load than the ProAcs, no?