New Maplenoll Ariadne owner needing advice

Thanks for the response. I just downloaded the manual. Also, your pics of your system is neat. Soon as the table comes in I will contact you. I like the external motor arrangement. That is very similar concept to my gyrodec.

At some point I'm going to construct a different arrangement for the motor. Channelling the motor vibes into the shlef is not the right way to handle this and that's what I'm currently doing. I want to make a matching corian and lead housing. I may also replace the motor with a less vibration prone one with accompanying circuitry.

Pierre at Mapleshade,and Lloyd Walker/Walker Audio can be of assistance on improving or retro-fitting the table

Oilmanmojo: Am I correct to believe that you purchased Greg Davis's Maplenoll that was offered on audiogon & Ebay to include a letter from Lloyd Walker outlining potential improvements to the table? If so , that letter along with Piedpiper's excellent recommendations should get you on your way. However, there is one more tweek that takes the old table to new sonic heights... But only for those who feel at ease with mechanical stuff and do not freek . Again, do not attempt unless you feel completely confident with your abilty to take things apart and put them back together again. I recommend to carefully dismantel the arm to the air bushing and inject 100% Iso-Alcohol into the bushing via the air intake port located on the under-side of the base(plith). The alcohol cleans out years of gunk build-up on the interior of the bushing and the air release holes . Make sure you have several cans of compressed air to dry the bearing once the alcohol runs clear. Do the same for the air-bearing base attached to the TT plith. Quite a messy job . Better still,remove those bearings completely from the TT base (plith) before cleaning . Returning those bearings to factory specifications by removing all the accumulated oil-crud stabilizes the air flow. It's sonically worth the effort to hear the TT as Bob Dilger /Pierre Sprey intended. Once the TT is reduced to its parts its a good idea to complete Mr. Walkers recommendations to the tone-arm & top of the TT air bearing. A change in tone-arm wiring maybe in order. Pierre Sprey recommends 40ga . I used 33 ga. Cardas via Michael Percy's web site that runs directly to the Pre-Amp capped with Bullett RCA's. Lastly, a word of caution no matter who recommends it--Do Not Burnish the Interior of the TT Air Bearing in the plith. That bearing has been "hardened" ; it can not be burnished unless re-hardened afterwards. That's too tricky for me. Other than a good cleaning and plugging the air-hole on the top plate w/ epoxy , leave the top and bottom plates alone. Cheers

You are right about the table. I have been working on getting a good compressor hooked up with it but using my shop air system the sound is pretty impressive so far. I understand what you are recommending and i will implement some of the ideas you passed on. I have noted that carefull setting of the air pressure is key to getting the platter moving freely. I have heard several comments around the higher pressure for the arm vs platter. I have also found that leveling the system is also very key in the free movement of the platter. I like the idea of cleaning the air ways especially the small ports since a little pressure drop can go a long way in this system. As I said to Greg, these hobbies can get quite consuming! thanks again for the suggestions. I am already enjoying what I am hearing and look forward to bringing this system up to even higher levels.