jetter
The basic assumption that makes this tweak viable is that there is not adequate electricity/signal reaching the equipment due to a loss from micro arching. Stated another way, that the designers of our equipment did not ensure that the full amount of power/signal was being delivered to our gear to ensure proper operation, that our power cords, fuses, rca and xlrs, and speaker cables and their connectors are so complicated and under designed to perform their intended function 100%?
>>>>>>Huh? What? That’s NOT the basic assumption at all! That is actually a perfect example of a Strawman argument - ranting about a false assumption, or a made up assumption. Nobody ever said micro arcing results in a loss of power. Nor does it. What micro arcing does result in is noise and distortion. That’s why all electrical connections in the house - including non audio connections - should be cleaned, at a minimum, to reduce noise and distortion. So, technically, it’s the Signal to Noise plus Distortion ratio that is affected. The power delivered to the gear is adequate even when the SNR Is relatively low. But micro arcing is not the whole story as higher conductivity of the connection is important as well, no? which is why Silver, Gold and Graphene are used in the first place.
There’s no substitute for high SNR. - old audiophile saw
The basic assumption that makes this tweak viable is that there is not adequate electricity/signal reaching the equipment due to a loss from micro arching. Stated another way, that the designers of our equipment did not ensure that the full amount of power/signal was being delivered to our gear to ensure proper operation, that our power cords, fuses, rca and xlrs, and speaker cables and their connectors are so complicated and under designed to perform their intended function 100%?
>>>>>>Huh? What? That’s NOT the basic assumption at all! That is actually a perfect example of a Strawman argument - ranting about a false assumption, or a made up assumption. Nobody ever said micro arcing results in a loss of power. Nor does it. What micro arcing does result in is noise and distortion. That’s why all electrical connections in the house - including non audio connections - should be cleaned, at a minimum, to reduce noise and distortion. So, technically, it’s the Signal to Noise plus Distortion ratio that is affected. The power delivered to the gear is adequate even when the SNR Is relatively low. But micro arcing is not the whole story as higher conductivity of the connection is important as well, no? which is why Silver, Gold and Graphene are used in the first place.
There’s no substitute for high SNR. - old audiophile saw