Noobie Question on speaker cable for my system

Jer;As an xmas gift I bought my sister a HC rceiver. Her's is a similar/something like avr300/ I got it new from a dealer for just less than $550. It has the cable box and a dvd player running thru it. She has PSB speaks---I just used lamp cord.----Keeping track of the + and - ribbed side of this lamp cord.--(So as to keep all speaks in phase). It does sound quite good if I say so myself. She is delighted as it was a nice improvement over the old "pro-logic"setup.One could easily spend more for the wire than the rec. Not to mention you can't use spades or anything fancy. Hi end speaker wire just isn't necessary for this. Get some lamp cord and----Just enjoy!!

I suppose it would depend on the length of spk. wire you would need. The AQ Type 2 is 17 guage and the Type 4 is 15 ga., I believe. On a short run the type 2 would most certainly be fine. If you're needing a really long run, I would chose the heavier ga. Type 4 wire. Just bought both the AQ Type 2 & 4 wire and I'm really impressed by both of these wires. (The type 2 I got used for a really great $. The Type 4 I order from Brian @ onecall.com for $2.25 ft.) If this is too much $ to spend, I would look into Tara Labs "Klara" spk. wire which would run about 80 cents a ft. Spend the the extra money and buy either the AQ's/Tara Labs or Kimber Kable's 4 VS would be an idea choice as well. IMHO, bare wire connections sound the best. Bill

Check out what the pro recording engineers often use: Canare StarQuad. Comes in two gauges (14 and 11), and is a ridiculous bargain for HT.

Thanks for the suggestions
Well I'll have a 5ft for the center and under 10ft runs for the front towers. Later on I'll have 20ft runs for the rears. At what length are cable lengths considered long?