2. amps-preamps
  3. 1369254217

Pairing problem with amp/speakers???

I have a pair of RBH 1266 speakers (4ohm), an Emotiva XPA amplifier ( 6 or 8 ohms), and a Pioneer VSX 52 receiver. When I increase the volume higher than -17 db the sound coming from the speakers fades then cuts out completely. I had a pair of RBH 1044's prior to the 1266's and did not have this problem. Could the problem be from the ohm incompatibility? If so, can anyone recommend an amp for my setup. I use the system mostly for listening to music. Thank you
cres98
cres98 OP
1 posts
 
Thanks. Any advice on the amp (brand and output) that I should replace the XPA with? Any help in the right direction is appreciated. I have about $1500- $2000 to invest in a new amp. Thanks again.
tonyangel
309 posts
 
Which XPA amp do you have? The XPA amps shown on Emotiva's website now are rated down to 4 ohms. I don't know why Marakanetz has such a problem with Emotiva gear, but I've found what I've seen to be good bang for the buck stuff.

Are you sure that your amp isn't over heating?

In any case, if you have 1500 to 2000 to throw at an amp, take a look in the agon classifieds. Your budget can buy you a lot of amp.
marakanetz's avatar
marakanetz
5,473 posts
 
Wyred4Sound ST500 is in your price range for new.
zd542
5,339 posts
 
"Thanks. Any advice on the amp (brand and output) that I should replace the XPA with? Any help in the right direction is appreciated. I have about $1500- $2000 to invest in a new amp. Thanks again."

If you want some good advice, it would be to stop right there. If I'm reading your OP correctly, it looks like you have a real problem. The sound shouldn't just break up and disappear just because you are running your amp a little hard. Something is either not hooked up properly or broken (or both). You need to figure out what the problem is before you buy anything. Check everything. Look all of your components and cables over really well. Plug your sources into different inputs on your preamp. Swap components out with others. Basically, do everything you can do to isolate the problem. Don't do anything until you figure out, for sure, what's wrong.

Anyway, thats my advice.
More to discover