power cords with active shielding

I had s disaster ofDynerhistic shielding 14 receptacles between 
Power cords ,interconnect ,and speaker cables ,plus 
Which really ticked me off they use wall warts .to get the better wall warts then the ones it comes with $400 Each  scam city and less then $10 of mini circuit board resistors and a few other  things 
If I am spending $ 1200 for interconnect  the $10 in parts better wall warts should come with it . My friend had non  active csbles 
From Verastarr for less or similar money and was a much more natural cable .I havd sold all my synergistic and Verastarr are my 
New go to cables .beware of all the optional add one before buying. Anything.

Regarding induced current in the “neutral” conductor, one reason to use balanced power is that both the “hot” and neutral conductors are energized, each at 60 volts, but 180 degrees out of phase with each other. This not only avoids the induced current problem but, as with balanced circuitry, causes powerline harmonics to cancel each other out.

Power cable hot and neutral conductors are carrying the same current in opposite directions being, in a sense, "balanced". Twisting them will make them exposed to external fields evenly causing cancellation. Same goes for radiated field from the cable. This works perfect as long as pitch of the twist is shorter than wavelength of the offending signal (4.9" for 2.4GHz). This makes practically no noise induction in ground wire. Twisting also increases capacitance (not important) and reduces inductance (important).

As for balanced circuitry - it does not reduce normal mode powerline harmonics the same way as balanced audio amplifier does not remove harmonics of the music - it only reduces harmonics produced by amplifier itself and only even harmonics (does nothing to odd harmonics). Balanced input supposed to reduce common mode noise. Power supply transformer does that already. Shield, in instrumentation/measurement amps cables, is usually driven with common mode input signal. This scheme eliminates capacitance between shield and signal wires for common mode noise reducing greatly capacitive pick-up. It works quite well, but I’m not sure if it makes any audible difference with power cables.

Guys, thank you for your feedback!

@kijanki 

My power cords appear to be picking up cellular activity in the 700-900MHz range.  So you say twisting them will help reduce the cellular signal I seem to be picking up?

@james1969 OP > My power cords appear to be picking up cellular activity in the 700-900MHz range.

Blindjim > sorry. I’m curious as to how you determined it is your PCs specifically which are inducing this extraneous noise and not some other cable, component, or power irregularity.