Power supply hum transmitted to loudspeakers

I guess a good question is how much noise emanating from your loudspeaker, once your system is energized, is normal? I avoid saying acceptable as we all have different tolerances.  When we place our ears 12 inches from the tweeter or midrange driver and hear a low level, buzz, hum or hiss, with nothing audible at the listening chair, is this normal/expected? When I run tube gear I often hear a low level hiss, with solid state a low level buzz, but no more than 1-2 ft from the loudspeakers. 

A question for Atmashere/Ralph:(and others who care to contribute)

With your fine OTLs and the sensitive loudspeakers you often use, can you hear any noise/hiss 1-2 ft from your loudspeakers at idle? My VAC amps and my AudioNote Kit Interstage Monoblocks both have low level buzz audible 1 ft from my KEF Ref 3's, not particularly sensitive loudspeakers. This occurs when they are plugged directly into dedicated outlets or my Torus isolation transformer. Thanks!

I'd like to share an observation.  Two days ago I moved my audio system to a really silent room that my stepson vacated. The room is extremely quiet but the components are closer as are the loudspeakers.
 Now that background noise has been virtually eliminated I can say that my two amplifiers that I thought were dead silent have minor transformer hum and there is a very minor buzz from my loudspeakers. Perhaps Brian is correct, above, concluding all components have very minor electrical or mechanical noise which should be ignored if not audible from the listening position.  

I can put my ear up to the tweeters in my rig and it's dead quiet, unless music is playing and then it's painful…so don't do that second thing…but try a Humbuster if you can find one. I do tolerate some hum from guitar amps, especially a single ended Class A Burriss Royal Bluesman head I use that has some hum that seems to emanate from my pedalboard…frustrating but worth it as the amp is so good.

With your fine OTLs and the sensitive loudspeakers you often use, can you hear any noise/hiss 1-2 ft from your loudspeakers at idle? My VAC amps and my AudioNote Kit Interstage Monoblocks both have low level buzz audible 1 ft from my KEF Ref 3's, not particularly sensitive loudspeakers.

I need to nail down some variables here. The speakers I have at home are 98 db; at shows they are either 98 or 107 db.

With 98 db I have to have my head by the mouth of the mid-range horn to hear anything. What I hear is a gentle hiss. With the 107 db speakers the hiss is more apparent- so we developed a little 'jumper plug' that replaces a tube in the voltage amplifier of our amps. With the plug installed where the tube was we knock out about 12 db of gain and then the hiss is back down to an acceptable level.

When designing an amplifier or preamp the challenge is that the end user might have a speaker of only 86 db (which is bordering on criminal IMO, due to the vast amount of power needed to make that work in most rooms, at least at the levels I like to play...), and at the other end of the spectrum is 107db. That's a range of 30db, which is 1000:1 in amplifier power (IOW, to do what an amp does on a speaker of 86 db, one need have 1/1000th the power to do it on a speaker of 106db)! Obviously this is a trick to make an amplifier of the same gain work on a range of speakers like that.

For this reason amp manufacturers tend to make amps of more or less gain depending on the speaker that might be used with their amps, which has a lot to do with how much power the amp can make. If a really high powered amp (+500 watts) the gain is going to be 30-36 db (there are some outliers; the Hurricane amp has 50db!); for a really low power amp that will only see use on speakers of +100db, the gain might be only 12-15 db. We typically set our gain around 25db, which is fairly reasonable to work on speakers from about 87db up to about 101db or so.

Keep in mind that on a really high efficiency speaker, its unlikely that you won't hear some sort of hiss or buzz coming from the electronics. It can get to be a bit of a challenge to design for speakers like that, even if your amp is only making a few watts.

So to answer your question with all that in mind, it sounds like you have a problem somewhere- with KEFs I would expect that you would have to lay your ear directly on the tweeter before you could hear any noise floor at all.