REL sub setup

I have a Storm III hooked up both high level, as discussed above, and low level for movies. I was told (by a guy a Tweeters which is why I'm asking) that the sub would automatically switch back and forth between these two inputs depending on the source. Also, what happens when I play SACD or DVD-Audio? I have the setting on the back set to high level. I was told I didn't need to change this. I am constantly tweaking this for nearly every movie or piece of music so that is why I am asking. It can sound fantastic, but it's pretty high maintainence right now.

Hey Ultraviolet,

I have two Strata IIIs and I've never noticed a switch from high pass and low pass. I've been running them for almost a year without having to touch them, except, of course, for the occasional adjusting of the crossover after changing a piece or cable(s) in my system. So sit back, enjoy and don't bother getting up to adjust the sub. I'm 100% sure the sub automatically switches back and forth depending on the signal it receives.......John

I'm not sure because it's not in front of me, but I think there's a knob with numbers 1-4. In the manual it says they are high pass 0 phase, high pass 180 phase, low pass 0 phase and low pass 180 phase. At least this is what I think it is. I have mine set to high pass 0 phase. If I'm not totally making this up, why would the sub have this switch if it auto detected? I guess maybe I should call REL...

Correct me if I'm wrong Jrwr7, but those independant knobs allow you to set the phase control for the different inputs independently, so when it auto switches inputs, the phase is customized for that input; you may want the phase setting different for movies than music.

Hey Y'all,

I've read the manual and on page five it explains the functions of the mode selector. I have my subs set to 4, meaning the phase is set to 180' and I have the LFE signal by-passing the ABC filter in the subs because I have my processor handling the crossover, thus giving the subs only the signal they need to reproduce through the RCA cable connection. The line level signal would need to go through the ABC to blend the frequencies properly with the speakers. The subs are receiving a full spectrum signal straight from the amp, through the Nutrik cable, so the ABC would filter out everything above the frequencies the sub is set to reproduce. I had to read the manual about four times before I felt I had it correct. I hope this clears things up.......John