I read the last two posts. Two things:
1) Yes, you can dial the SDS up until you get to 33 1/3, but something is still wrong for the speed to be off by that much. I think it's worth getting to the bottom of. However, while you're debugging the problem, by all means ramp it up and get your records spinning!
2) If power delivery was the issue, I think your speed would be all over the map, rather than just slow. (Unless you live in a permanent "brown out" zone.)
Check the items mentioned in the previous posts, if platter, bearing, belts, etc. all check out fine then give VPI a call. They are very helpful.
Cheers.
Tom
1) Yes, you can dial the SDS up until you get to 33 1/3, but something is still wrong for the speed to be off by that much. I think it's worth getting to the bottom of. However, while you're debugging the problem, by all means ramp it up and get your records spinning!
2) If power delivery was the issue, I think your speed would be all over the map, rather than just slow. (Unless you live in a permanent "brown out" zone.)
Check the items mentioned in the previous posts, if platter, bearing, belts, etc. all check out fine then give VPI a call. They are very helpful.
Cheers.
Tom