@sdw : OP, what is your amp? And your speakers?
Single vs Bi-wire Speaker Cable
I'm going to purchase some AQ speaker cables, and am considering bi-wired AQ Robin Hood Zero vs full range William Tell Zero (with quality jumpers). The bi-wired RH is about $500 more expensive than the full range WT, but on a comparable basis, WT is the more expensive cable. Any thoughts on sound quality between the options I described above would be greatly appreciated.
- ...
- 45 posts total
@thyname - You are correct good sir... They do suggest using the top posts on the 802D in the manual. My mistake 🙁. Maybe that is why I heard such an improvement when bi-wiring mine. FWIW, they do recommend bi-wiring in the manual though. |
@boxer12 : no worries whatsoever. I know this because I own B&W Diamonds 😉
And I do use two speaker runs from my amp to my speakers. My amp has dual speaker taps |
👍 @thyname |
@thyname "And I do use two speaker runs from my amp to my speakers. My amp has dual speaker taps." One question and one answer follows: 1. Do you think two speaker runs are better than bi-wiring with one cable? 2. My amps are two PS Audio M1200 mono-blocks and my speakers are B&W 802/D2. |
- 45 posts total