2. speakers
  3. 126118-15738

Songs Faber Olympica III

Just got a pair of these speakers. I’ll be setting them up tonight. Hoping that I can benefit from the accumulated wisdom here...

Any tips from current owners? Setup, positioning, burn-in (although mine were previously owned, so burn-in shouldn’t be an issue), spikes versus no spikes (mine are on hardwood floors in the basement, meaning there's a concrete slab underneath), etc.

(I do know that I have the choice of positioning them so that the ports will either face outward or inward, and I glean from reviews that I should try it both ways to see what sounds best in my room.)

Any tips are greatly appreciated.
chipcarterdc
aolmrd1241
1,043 posts
 
chipcarterdc said ... "Question: what would happen if I connected the low/bass input to the 2ohm taps rather than the 4ohm, and then either left the high input connected to the 8ohm or moved it down to the 4ohm?
By "what would happen," I mean both "what would one expect to hear" and "am I going to blow something up if I do this"?"


Try it out and see what the outcome is,it may sound better, or worse,only you and your ears can be the judge.. I do not think anything will blow up as you say...as long as you do not put the amp into clipping... I would think everything would be fine.




chipcarterdc OP
22 posts
 
Thanks for all your responses!

Dealer is sending me the shorter spikes.

Starting to form solid impressions now after a few days. Really enjoying them. I’ve noticed that i do need to have the volume a tad higher than I usually do for them to really sing. At low levels, they sound quite good but pretty laid back/a bit too "polite". Just a slight volume increase really brings them to life. And no, not just because they’re louder: everything improves (width and depth of soundstage, separation of the instruments, realism of the vocals, etc.)
aolmrd1241
1,043 posts
 
Being to polite I believe could be a system dependent thing. While listening at low volume settings with my III’s everything I hear at a louder volume’s is also there at lower volumes...just not as loud of course. Low loudness levels for me, at least, are just plain superb with the musical spectrum refined and preserved. Sonus faber claims a sensitivity of 90db/w/m but I believe it is closer to 87db/w/m from a review I read. Combine that with an average Impedance of 3 ohms( dipping to 1.7) and it’s easy to see they like a bit of juice to get them going...

soundsrealaudio's avatar
soundsrealaudio
756 posts
 
Boy I love that cute little dart on the tweeter. Must bring it to life.
dnn's avatar
dnn
3 posts
 

Hi to All !

 anyone here ever opened  the Olympica IIIs before , Please help  me with the instruction of how to open to check insde .My 2 woofer not working when measured across the terminal it is not 4 ohm (neither woofers or cross over went bad i think ). Greatly 

More to discover