Speaker Cable for Interconnect

Sugarbrie is correct about Nordost Magic -- it is the same
cable as Nordost flatline. I own both, and have read
press releases from around 1996 when this cable came to
market. So, yes - you can!

Thanks for the responses. Then we all should be able to make cheap IC out of bulk speaker cables for a lot less than buying already-made ICs.

BTW, from the picture of Kimber PBJ, what is the 3rd run used for if 2 runs are for "hot" and "ground"? I trying to mimic Jon Risch's DIY unbalanced connection using coax which only requires 2 separate conductors for each single IC.

The third conductor in PBJ is a drain(sort of a shield wire) wire which is connected only at the source end to the "ground" side or the RCA. I hope someone will correct me if this is wrong.

I think that the PBJ's use double grounds and one hot. From what i can recall, the grounds are connected at both ends, so there is no "drain wire" in this design. I have some on my burner, so i'll take a look tomorrow and correct this if it's wrong. Sean
>

I was not sure and Sean may be correct, the only pair of PBJ I have around are in a system I put together for my Wife and have a stupid DIN plug on one end to hook up a "normal RCA" CD player to an old Naim Nate.(NAD cd,Nate,Rogers Ls35a)I don't want to fiddle around in that DIN to see what is going on.Off the subject, this little "Britt" system is alot of fun! Tally ho!