Speaker cable length for mono blocks


I shall soon be attempting to either vertically biamp or mono amp a pair of speakers. I can put the amps within 6" (inches) of the speakers if I wish. Should I connect the amps to the speakers with very short lengths (less than 2 feet) of quality speaker cable (12 AWG or greater) or should I hook up a conventional length (eg. 8 feet) of cable? The amps will be Pass Alephs and the speakers will be electrostatics.
Ag insider logo xs@2xivanj
I have a very similar setup, with Aleph 3's and Quad ESL 63's. I tried it first with 8' Stealth Ultimate Ribbons and then with 18" lengths of the same cable. My experience: it is VERY MUCH WORTHWHILE to go for the shorter length! The 18" cables brought me MUCH closer to the music. I thought it was very good before, and maybe it was by any reasonable standard. But this was one more reminder of the audiophile mantra, "It can always get better."
The shorter the better. I have about one metre of what I think is Ultra Cable, which was highly regarded cable ten, twelve years ago. I have never felt the need to improve on this. One of the advantages of mono blocks, I think, is that you are able to position them close to the speaker. The idea is to keep the amps clear of the speakers so they don't interfere with dispersion (limits this to the sides with dipoles unless the amp is kept on the floor below the transducer element itself) and air circulation, and to keep the interconnects short also. No point in having long runs of interconnect to compensate for extra short speaker cables, unless they are balanced. On the subject of cabling, it is interesting to read what the Bryston site has to say before going off the deep end cable-wise. Interconnects and speaker cables are a fools paradise, so beware.
The shorter the better less resantace. The other point is you can get a much better cable.
this is yet another of those queries that has been posted more than a few times. (suppressing big YAWN here to placate tonite's chosen moderators.) to save all those who find audiogon's search engine impossible to fathom, here's the consensus: shorter is better (but only with cables) unless you care a whit about resale value, in which such case you should use nothing shorter than 4 feet each side. -cfb
Sorry if I bored anyone (cfb.) Ninja, does a better cable really matter in this situation of short short length as long as basic parameters of sensible gauge, low resistance, capacitance,and inductance are followed?