Sub DIY vs mass produced?

If you want to beat or at least equal everything out there then you need one of these drivers.

I am going to try a paradigm x-30 for now. I was told to get a outlaw x-over (icbm1 or something like that) but I couldn't find one. So I am going to try the paradim x-over & I will see how it works.

& yea, mostly HT.... but if I can get it to blend properly for music I would use it along with my infinity kappa 8.1 vII's. So I want it to be very musical....

My girlfriend is actually moving in & we are combining our stereo's. Her receiver is about 8years newer then mine (I have a old Denon AVR-3000 & she has a yamaha something.... made is 1999 I beleive) & has sub volume controlls. She has 2 mirage 8 in powered subs & I think they sound horrible... boomy & no low end. I do plan on updating the receiver to something new withing a year or so (I want a processor but time will tell).... when that happends I might try to find one with a internal x-over but I am a ways from that.

Damn, Shadorne, this one FINE woof woof. 80 lbs. - whoa! $1800, WHOA! Looks like it's worth it, though...

Viggen, whne you get ready to replace that receiver, go take a look at the Emotiva UMC-1 or XMC-1 pre-processors. Killer units for not much money. And their matching amps, XPA-5, UPA-7, etc. are quite the bargain, too. You could put together a smokin' surround sound system (electronics only) for right around $1200 - $1800.

Good luck!

-RW-

yea... those sub specs were definantly impressive!!!! But it better be for what they are charging.... OUCH :)

I will try to remember emotiva... I was considering sunfire (read lots of great stuff about them) & a few others..... probably used.

If the receiver has a subwoofer output (RCA out) then you already have a built-in crossover and don't to need to buy another -- unless you are not satisfied with the sound quality, and want to move up to a newer preamp-processor. Anything (receiver or pre-pro) with a dedicated subwoofer output will have a subwoofer level adjustment among the volume controls, so you don't need that feature in the sub itself, nor do you need to buy a separate crossover.

www.diyaudio.com has a whole section devoted to DIY subwoofers. I would not spend megabucks on an 80 pound driver -- those are mainly just for bragging rights, or subwoofer envy if you will.

I bought a "New Larger Subwoofer" kit from www.vmpsaudio.com and have been very happy with it. I don't know if they still sell them as kits or not. It has a 12 inch driver, a 15 inch driver, and a 15 inch passive radiator in one big cabinet, which I disguised as a pedestal for a sculpture. You could also disguise it as a coffee table. My only complaint is that the subwoofer causes nearby plastic objects like my computer tower to rattle loudly during heavy sound effects, which is not the subwoofer's fault. I power my subwoofer with an Adcom GFA-555, the predecessor of the 5500. It works great.

Have fun and give us a followup.