2. home-theater
  3. 157833-102920

Sub Not Waking Up

I have a Yamaha CX5100 Receiver and two Sunfire HRS8 subs.  I moved my equipment around in my cabinet, got a new am to power my R/L, and new R/L speakers.  I am still using the same center, rear, and 7.1 channel amp to power the others.  

My problem is my subs will not turn on.  I ran the Yamaha YPAO and sound came from them and it configured them at 2.5.  But after they will not work.  I think they are going in standby and not getting a signal to turn on but for the life of me I cannot figure out why.  

I have another Velodyne sub in another room and it works fine and the Sunfires work fine in the other system.  It is just the sunfires with the Yamaha.

Any suggestions would be appreciated.

Thanks,Mobius
mobiusmu
imhififan's avatar
imhififan
2,211 posts
 
@mobiusmu 

I know this may seem elementary, but do your subs have gain control? Make sure they are turned-up if so.
+1
Or use a 12V trigger outlet for the subwoofers.

https://dlidirect.com/products/iot-power-relay


deep_333
1,543 posts
 
most probable problem:
a)You probably have the volume control knob on the sub way up.
b) YPAO may have compensated when it does it's level matching with your speakers by turning the level way down for the sub. The signal the receiver sends now is insufficient to "wake up" your specific sub during playback.

Solution:
Start turning down the volume knob on the subwoofer unit such that YPAO is setting sub levels to +3dB or more when it does its level matching. The receiver should send something big enough/sufficient to "wake up" your sub. 
bkeske's avatar
bkeske
5,597 posts
 
Actually YPAO is notorious for setting the sub level via LFE too low regardless of the gain setting at the sub, which as I said, thus I always adjusted it manually when using LFE with my receiver. Albeit I don’t do that anymore.

But yes, as I also said, most probably the sub gain is set too low.
More to discover