2. speakers
  3. 1017105642

subwoofer setup problem

I am trying to mate an ACI Titan II with my Thiel 22. The Thiels go down to 30 hz but the lowest crossover on the Titan is 35hz. Thus, there is an annoying overlap in frequency. I am considering several possible options and would appreciate some input. They are (1) get a REL sub whose lowest crossover point is 28 hz. (2) get an active crossover and cross my mains at a higher point. (3) use a passive 65hz filter between my preamp and amp that ACI has.
The passive filter is the cheapest route but will it do more harm (to the sound of my thiels) than good?

Thanks
Greg
kadlec
maxgain
526 posts
 
Greg,You would do better to try setting it higher than 35Hz before you change subs or cross overs. Try moving things around a bit as well. Sounds to me like you would have a huge hole or suckout instead of an overlap the way you have it set up. My sub is set up differently than the ACI or REL so maybe I am way off on this one?
sdcampbell
2,136 posts
 
The general rule-of-thumb for integrating subs and main speakers is to allow a one-octave overlap. Hence, if your main speakers were flat to 40 Hz, you'd want the subwoofer's crossover point to be about 80 Hz.
maxgain
526 posts
 
Scott, is that the case when the main speakers are not rolled off?
That was my idea as well but I have no experience with subs that are not really bi-amped with some sort of slope on the main speakers.
More to discover