2. amps-preamps
  3. 135544-81968

Switching a single set of speakers between two amps

I search all of the posts first, and found one discussion about this topic, 4 years ago, but it wasn't exactly the same as my situation, so I am going to bring it up to see if anyone has experience with this.

Right now, I am using my AV system in conjunction with my analog system - I have a Garrard 301/Jelco 750L/Zu Audio 103, feeding a Tavish Adagio, which then rolls into an NAD T187/Classe CA5300, connected to KEF speakers (stereo pair are the LS50s, which might be the biggest bargain in audio -I used to run Maggies - the 3.7i's, which are great speakers but turn out to be wrong for my room - contact me if you want to buy them! - I initially purchased them for a different environment, where they worked great, but they are too large for the room I am in now).

What I want to do - continue to use the NAD/Classe system for A/V and also for surround SACD, but install an integrated tube amp - maybe the Line Magnetics 518- for use with vinyl and tape.  I located one well-reviewed switch - the Beresford TC-7220 - and I wanted to see if anyone has actual experience running two different amps with the same speakers, especially when one of them is a tubed amp.
tgr
wspohn's avatar
wspohn
610 posts
 
I have also looked for a simple convenient solution to this question. At present I have my speakers operated either by my hifi front end (all tube) or by an AV system with AV preamp and solid state power amp.

Not too onerous to switch as both power amps sit between the speakers and I use banana plug speaker wire ends, so it is just a plug and unplug operation (keeping in mind almarg's caution about the tube power amp being turned off).

Wonder how transparent the Luxman unit is?
astelmaszek
125 posts
 
I can't tell a difference between Luxman in the way and without but then I'm not a strong believer in cables so I don't see how a well executed relay system like Luxman (basically same design as their integrated amps) would contribute or subtract anything from the sound. Copper is copper.
secretguy
1,751 posts
 
I use the same speakers for both 2 channel and HT....I simply switch cables.
imhififan's avatar
imhififan
2,211 posts
 

I used Niles SPK-1 and SAS-1
When the AVR power up, the 12V trigger output from the AVR triggered the SPK-1 switch AVR output to Main speakers, the SAS-1 line level switch the sub-woofer input to AVR, and the speaker level switch connect a 25ohm100W resistor to each of the tube amp output channels.
More to discover