Are you sure the M120 is not available? Did Mike tell you that?
http://quicksilveraudio.com/products/mono-120/
http://quicksilveraudio.com/products/mono-120/
Then there were 2
Are you sure the M120 is not available? Did Mike tell you that? http://quicksilveraudio.com/products/mono-120/ |
One thing to note if using the RP7 as a pre, (from Stereophile's measurements): " As a result of the increased output impedance at low frequencies, the RP-7's response drastically rolled off below 400Hz into 600 ohms, reaching –3dB at 200Hz (fig.1, cyan and magenta traces). The RP-7 should not be used with power amplifiers having an input impedance much below 30k ohms. Into 100k ohms, however, the RP-7 offers a flat, wide-bandwidth response with an upper –3dB frequency of 170kHz" Keep in mind the input impedence of the power amp you will be using with it. I have an RP7 and a Stereo100 and the match is lovely, as it should be with the same brand. |
my own 2 way speakers two MW16P and TW29R Satori drivers.Is that between 2 cabinets or just in 1? Do you have any idea of the efficiency and impedance of the speakers? In a room that size 100-130 watts will work if the speakers are 92dB although you'll be able to run the amps out of gas if you really push it. If the speakers are 4 Ohms you might need more power. |