Thiel Owners

tomthiel,

The base can be whatever design one prefers. Ideally it should also add stability to the speaker. I have CS 7.2 and CS 6 which are fairly heavy so I did not them to be tipsy. 

I used the threaded inserts at the bottom of the speakers and ran a threaded brass bolt with a spacer to couple the speaker to base. 
Apply some footers and your set. 

This material is sonically superior to aluminum. One who benefit from an aluminum outrigger. With the Panzerholz the audible difference is very obvious. 

beetlemania

Thank You for the follow up. When I contact AYRE about upgrading to the Twenty Series, I will inquire about replacing the stock Fuse(s). In the event Ryan or one of the other guys recommends a certain brand of fuse, will post the conversation  here.

Happy Listening!

duramax747

Good to see you here again. Thank You for posting information that may be of value to others here regarding Outriggers.

During my auditions (CS 2.4, CS 2.4SE, CS 2.7 and CS 3.7), it was interesting to observe how model CS 2.4 SE responded a measure sonically versus the other 3 loudspeakers. It was a very subtle positive reflection to my ears. Sharper in focus, imaging and soundstage. A considerable amount of time was spent with CS 2.4 prior to auditioning models CS 2.4SE, CS 2.7 and CS 3.7 loudspeakers.

Outrigger use, or not, exhibited no impact on  models CS 2.4, CS 2.7 nor CS 3.7.
Each loudspeaker sounded very fine with/without Outriggers. 

Are you products still in Research and Development?

Happy Listening!

Are your Products still in Research and Development? :corrected.