Hi @jafant , appreciate the warm welcome and you have been moderating a great topic! Make any changes to your 2.4 SE's? I'll share more on musical tastes and system in the next few evenings after work.
Thanks for the correction @vair68robert! I should have said series (Rt = R1+Rn) vs parallel with just 2 resistors as the site you link pointed out Rt = R1*R2/(R1+R2). You are right about capacitor sizes which was reenforced looking at @beetlemania crossover pictures. The switch to Masonite seemed to be required at some point for film capacitors and perhaps even for the resistor switch using the 2 resistors you kindly provided or the 2x8ohm I have. As @tomthiel said, is "not so simple" and my mind hasn't quite fully realized yet. Quite a lot to learn.
Hi @tomthiel, I appreciate the information and clarity. The project with duramax747 will certainly be of interest as I don't have a clear understanding of the desired end scope. The new layout scheme, ClarityCap PUR and more learnings along the way would be good to know before going too much farther with the build.
Frankly, my technical knowledge is being relearned from a job building magnetic card readers for video game arcades back in college 25+ years ago, so it is rusty but starting to comeback and expand. Part of going with ClarityCap SA capacitors from Rob to get the crossovers in hand and study the existing design beyond photos and documents. It was a straight forward update vs CSA (i.e. 27uf+1uf, unknown size constraints). Good learning experience plus, out of pure curiosity, I wanted hear what the SE model might have sounded like. Not too logical from a project perspective though the SE sound has been enjoyable.
Audiogon might have a minimum requirement for sending a PM, so either I missed how it's done or needs to be enabled. Will send one when that is figured out. It's been many years since being on a forum.