Why try to isolate anything, it cannot be done. You will waste your time, money, and only be frustrated with the results. Oh yeah, there will be a difference, but how often do we mistake differences for genuine improvements? Common to all systems is ground. There are products that collect spurious noise, those generated both internally as well as externally and speed their exit to ground. These devices have made a marked improvement in every system device I have tried them on. Rubber does not improve reality, it only detracts from its ultimate sensation. The transfer of energy must not be impeded but must be inhanced. Do you buy speakers because they are slow and sluggish? Have you replaced all of the high speed output devices in your mega-buck amp with 1960's technology? Increasing the sensitivity and efficiency of any device can be provided by a high speed transfer of resonance to ground. Remember the phrase "Get the lead out"? Well grandmom was right about that, it also slows energy transfer down.
thoghts about isolation.
Our discussion has to take place with mechanical isolating non-source components such as amplifiers and preamps.
My thought was wether we realy need to mechanically isolate non-source components or not. The impact from internal vibrations caused by the mainly power supply transformer will less-likely affect the operation of active elements fo the circuit such as tubes or transistors imo. The same thing comes onto mind about passive elements such as resistors and capacitors. What can affect the performance is the electrical isolation of power transformers especially in the power amplifier domain(that's why I prefere not using integrated amps). That's why it's very often beneficial to have an outboard power supply(not necessary battery) for the preamplification(phono, line or DAC)
I want to give some example where I've seen the PS300 power plant placed on the tip toes and I wonder why?
If we take source components, there are certainly good reasons for it such as mis-recepting the laser beam by CD transport or mis-tracking the record that can even be cause by the measurable amplitudes. In addition for the turntables the amplitude of a signal can somehow be matched and certainly cannot be neglected with amplitude of intermal vibrations caused by friction of a platter, motor that is transfered to the tonearm and cartridge as well.
IF YOU'RE LAZY TO READ THE WHOLE THING YOU CAN ANSWER JUST THIS GENERAL QUESTION:
Do all audio components need to be mechanically isolated?
My thought was wether we realy need to mechanically isolate non-source components or not. The impact from internal vibrations caused by the mainly power supply transformer will less-likely affect the operation of active elements fo the circuit such as tubes or transistors imo. The same thing comes onto mind about passive elements such as resistors and capacitors. What can affect the performance is the electrical isolation of power transformers especially in the power amplifier domain(that's why I prefere not using integrated amps). That's why it's very often beneficial to have an outboard power supply(not necessary battery) for the preamplification(phono, line or DAC)
I want to give some example where I've seen the PS300 power plant placed on the tip toes and I wonder why?
If we take source components, there are certainly good reasons for it such as mis-recepting the laser beam by CD transport or mis-tracking the record that can even be cause by the measurable amplitudes. In addition for the turntables the amplitude of a signal can somehow be matched and certainly cannot be neglected with amplitude of intermal vibrations caused by friction of a platter, motor that is transfered to the tonearm and cartridge as well.
IF YOU'RE LAZY TO READ THE WHOLE THING YOU CAN ANSWER JUST THIS GENERAL QUESTION:
Do all audio components need to be mechanically isolated?
- ...
- 22 posts total
- 22 posts total