No flaming. My attitude about spending gobs of money on NOS tubes is kinda like buying expensive flowers. Sooner or later there going to die...LOL I'm not a big fan of NOS output tubes. The D115mkII was designed around the Philips/Sylvania 6550. Look for a set of those. BTW just because the voltages are ok on the amp doesn't mean the voltage regs are quiet. That's important too. Noisy voltage regs. have a negative effect on that amp. Also, there is a B+ reg and a buffer reg. Make sure the voltage differential is the same or close to the circuit diagram. If the power supply caps are more then 20 years old, replace them. All new caps will make the amp sound better especially in the bass provided there's nothing else wrong with it. There are a few axial caps scattered throughout the amp. Replace those as well. On top and underneath. There is also a 27K ohm resistor near the main filter caps. Make sure it measures 27K. Those do open with tube arcs. There should also be red cap plugs on the capacitors. The support bars always get bent because people try to lift the amp with them and their aluminum. You can remove them and straighten them out a bit to get some of the kinks out. Use a rubber mallet, however the rack handles will come off too. Do one at a time. I strongly suggest you make sure that amp is in good working order before you attempt to modify it.
