Thoughts on moving from a 1200G to Sota Saphire or above

Not a big fan of SP10 mk2, but I do agree with Atma and Chak that the OEM rubber mat is a negative and should be replaced. I think the top line Technics G series with a selected mat might outperform the mk2, but I have no experience to corroborate my hunch. For that matter, the felt mat on my Star Sapphire was also not optimal, but vacuum hold down required it. Comparing Mk2 to a full up Cosmos with Eclipse is kind of a cheap shot, IMO. The price difference is cavernous. You could add a Minus K to most vintage DDs and still be well under the cost of the fully equipped Cosmos. But I’ll not argue that the Cosmos is not excellent.


The “unrepairable” tag on the older Technics won’t wash. All needed parts, tech data, and schematics are readily available, and there are several competent repair shops. As to the bearing, caveat emptor. I’ve never owned a vintage deck that needed more than to clean and lube the bearing, and DD bearings are likely to last longer than a belt drive bearing, because no side force.

@lewm 
“Not a big fan of SP10 mk2”

Might you elaborate a little ?

@mijostyn thanks for the feedback on the Sota. You give me a lot to think about. I could try it and if I don’t like it go back to the 120G as others have done. I plan on checking out the Sota today or tomorrow. As far as the SP10, unless I can pick it up for a song, don’t think I’ll make a move on it. Just too last minute of a discovery to vett out during my brief stay in H-Town. 

SP-10mk2 drive cost $1500 maximum! With old SME tonearm and some unknown custom plinth for $3500 it’s too much! All you need is drive, the rest you can buy yourself (better tonearm and better plinth).

For $3500 you could buy Luxman PD-444 (complete)

Tsushima, I have owned two samples of the SP 10 mk2. During the same timeframe, I also owned and still own an SP 10 Mk3, a Kenwood L07D, a Victor TT101, and a Denon Dp80, not to mention a highly tweaked Lenco. At one time or another I heard all these TT s in the same system. All of my turntables were fully refurbished and calibrated  before I started to use them. The Technics and Denon tts were replinthed in PA slate. In this bunch, in my opinion, the SP 10mk2 came in last. I thought it had a grayish coloration, compared to any of the other direct drive turntables. I also have to disagree with Pani, when he said that the mark 2 and the mark 3 sound about the same. In my experience, there is no comparison, Mk3 is in a different world. Tonally very neutral and very precise with a big sound space.. My Mk3 has the Krebs upgrade; my mk2s did not. But even before Krebs, Mk3 was superior.