That has been my experience as well sciencecop. FWIW Brass seems to dampen aluminum very effectively in combination with soundcoat material (1/16" thick sheets).
Tonearm mount to the plinth vs arm board vs rotating arm board vs isolated tower
Hello,
I am rebuilding a Garrard 301 and looking for a plinth. I am planning to buy 3-4 tonearms to try. I would like to know which is the best way moving forward.
Is there a difference between mounting a tonearm directly on a solid plinth vs arm board (same vs different materials) vs rotating arm board vs isolated tower.
Thanks
Nanda
I am rebuilding a Garrard 301 and looking for a plinth. I am planning to buy 3-4 tonearms to try. I would like to know which is the best way moving forward.
Is there a difference between mounting a tonearm directly on a solid plinth vs arm board (same vs different materials) vs rotating arm board vs isolated tower.
Thanks
Nanda
- ...
- 112 posts total
05-12-2020 1:23pmIn the case of the first you have a subjective means to winnowing out how a separate arm pod is a failed concept;THE ATMASPHERE PRINCIPLE Thank you for reminding me of why I dont use rubber belt drive turntables or direct drive turntables - the swirling and lurching from note to note of a platter driven by a rubber band vs the grainy grey wash of the direct drive as it interminably tries to calculate the correction speed required on ancient "software" using 1970's electronics, not to forget that a can of Baked Beans probably has more structural integrity than the motor housing on the DD. And to think you can even hear it with a low res MM. Thanks again for reminding me. |
Thank you for reminding me of why I dont use rubber belt drive turntables or direct drive turntables - the swirling and lurching from note to note of a platter driven by a rubber band vs the grainy grey wash of the direct drive as it interminably tries to calculate the correction speed required on ancient "software" using 1970's electronics, not to forget that a can of Baked Beans probably has more structural integrity than the motor housing on the DD. And to think you can even hear it with a low res MM. Thanks again for reminding me.Perhaps you'd like to make a YouTube Video to show us the superiority of your esteemed system @dover ....? What was that........? Can't do...it's raining in New Zealand....videos can't show shit....my finger's broken.....Ain't it great when you can spout 'garbage' without having to provide proof or evidence...🤥 You could fill Audio Forums with your 'wisdom'....🤗 |
DoverBut then.... DoverTo this..... DoverAnd this.....? DoverAnd this....? Dover To this again....? DoverAnd from this....? DoverTo this.....? DoverPerhaps Dover needs 'constant' reminding......🤗 |
Dear @halcro : The failed concept is failed by physics law. That we like it the listening experiences through it does not means is " rigth ". In the other side your post making comparison about is useless when the comparison you wanted show was with different TT, different tonearm and even different LP track and probably not exactly the same accurated alignment set-up. R. |
- 112 posts total