Transient Attack and Amp Design

Saki70, the difference between 8 and 4 ohms can be all that it takes; nearly every amplifier made will sound faster (as well as less bright, more natural) on a speaker of higher impedance.

02-16-09: Shadorne
Transients require large amounts of near instantaneous current without the voltage in the power supply dropping. Essentially the bigger a power reservoir you have the better an amplifier can cope with transients. It matters less how the power is stored (a capacitor bank or a couple of large capacitors compared to the total amount of stored energy).

Your comments point to what I suspected. Now does the transistor proximity to the storage cap(s) make a difference? McCormack puts the caps close to output(?) transistors rather than a considerable circuit distance as I saw in my sunfire and marrantz amps. Or are we talking nanoseconds and thus it is not a significant consideration?

BTW, thanks for everyone's comments thus far!

Now does the transistor proximity to the storage cap(s) make a difference?

Atmasphere can speak to that more knowledgeably than I can, but I don't think that would make a significant difference. The concern would not be propagation delay (which would be a few nanoseconds at most, as you speculated), it would be that the inductance of the wiring or printed circuit board traces between the capacitors and the output devices would slow the transfer of energy.

But I don't think that would be a significant effect either. As a very rough ballpark the inductance of one foot of straight wire is around 15 nanoHenries, which would have an impedance of about 2 milliohms even at 20kHz, and much less at lower frequencies. The numbers would be somewhat different if printed circuit board traces were involved, rather than discrete wiring, but I would think they would still be totally insignificant.

What would be of potentially greater significance would be noise pickup on those runs, but that is presumably filtered out by much smaller decoupling capacitors (that have much better high frequency performance than electrolytic storage capacitors), which should be and presumably are located very close to the point of use in the output stage area.

Regards,
-- Al

Jragsda, glad to hear you are enjoying your DNA-1.

I came up with the DNA (Distributed Node Architecture) design specifically because I do believe that it is audibly beneficial to eliminate (as much as possible) the connectors and wiring between the output devices and the source of their "instantaneous" current. At the same time, the capacitors used may be smaller individually and still add-up to a large effective capacitance. The capacitors still have to be carefully chosen for their audio characteristics, but it has been my experience that these physically smaller caps often have better audio performance (particularly at high frequencies) than their larger brethren. While it is difficult (or impossible) to defend this position from a strictly engineering / measurement standpoint, I note that a fair number of other amplifier designers have adopted this technique since the DNA-1 came out.

Best regards,

Steve McCormack
SMc Audio

Hi Steve, I think there is plenty of evidence out there to support your position regarding smaller caps!