2. analog
  3. 136575-9158

TTW Parts

If you read my other post I wanted advice about vintage Thorens TT.The  reason being I'm having a difficult time finding parts for my TTW Table. I was able to get the rubber O-Rings for the rim drive but suspect they are too hard. I am getting vibration from the attached motor and could hear it. Does anyone know where I can find the proper O-Rings and Belts for the table. I have a good amount of money invested in the table but cant tolerate background noise.
cjaronica
cjaronica OP
113 posts
 
Thanks I will try to find them. I also have the duel belt drive that I am
 using now. Very quiet but a pain to get on.

cjaronica OP
113 posts
 
I Just ordered the Buna O-Rings will let you know how they worked out. Thanks
benjie
329 posts
 
I am using these o-rings with my copper platter Momentus TTW turntable. They are very close to the clear ones that were an option with the rim drive set up. I have had a lot of success with them. They are very quiet and last a long time. I see people are using 1/16" wide o-rings. Too thin, they will transfer noise to the platter. These are 1/8" wide which is what you want to use.
 
206 Polyurethane O-Ring, 70A Durometer, Round, Translucent, 1/2" ID, 3/4" OD, 1/8" Width (Pack of 5) https://www.amazon.com/dp/B0053V30TY/ref=cm_sw_r_cp_apa_i_JtHmCbVXB59NK
cjaronica OP
113 posts
 
Thanks I have not found any rings yet that worked I will give theses a try
benjie
329 posts
 
cjaronica OP
 
Was wondering how you made out with the o-rings that I recommend.
More to discover