Tube mixing

Wolf!! Disparate tubes next to each other? Un-matched quads in a tube amp. Don't do it!. You will upset the cosmic tubeworld balance. I'm going to short circuit as well. (I don't think I will ever be as funny as you.)

Anyway I'm curious to know what membership has to say as well. In the other tube amp I have there are 2 6L6GB tubes and 2 6V6GT tubes used together. The amp is supposed to have a quad of 6L6 tubes. From what other tubeophiles told me the split set-up I have in that amp is ok. I just have less power/channel. I never got around to having a quad of 6L6 tubes put in because I had to pay a tech to re-bias and check out the amp.

I'm talking about one of each in each channel...I think somebody has to ask these questions. No question that 2 matched pairs of different tubes in each side is no biggie and results in what you described, but what I'm proposing is much weirder, and probably illegal.

Here's the problem with different tubes on one side of a push-pull amp.

I assume you're familiar that a push-pull circuit divides the signal into two halves (usually shown as a top & bottom referenced by a center line), amplifies each separately, and rejoins them at the output.

Using a simple sine wave input where the top half of the wave is a mirror of the bottom, a 6550 tube is going to have "X" amount of gain while the KT88 or KT120 will have a different amount. At the least, your output push-pull wave will no longer be a more powerful duplicate of the input push-pull signal. You will have distorted the wave.

Depending on circuit design, this could also make the amp unstable.

Even if the amp is designed to accommodate all the tubes involved, I wouldn't recommend this kind of mismatch unless the situation was desperate (i.e., an audience waiting for a performance and no other possible way than this for the show to take place).