Tube temperature for ARC Ref 6

I recently put Herbies Ultra Sonic tube dampers on all the tubes in my REF6.  Unfortunately, I can't tell you what difference they made, as it occurred at the same time as the installation of a new set of tubes from ARC, plus pasting the tube pins and back panel connectors with Total Contact.  It all sounded much better when re-inserted into the system.

 Everything seems slightly more solid with more air as I remember. It has been quite awhile. I know people that have put them on 6550 tubes but I have not. tried  Only you can decide if they are worth the cost..

tattooedtrackman, I may have mislead you some. My temp reading with an infrared thermometer was thru the top cover and not directly on the surface of the tube. So the surface temp maybe higher and I am sure it is. And my highest readings were the 6550, and also were indicative of the amount of cooling I gained. The 6550 does run a lot hotter than th 6H30, which I am sure is some of the motive to replace them at 2000 hours instead of 4000 on the 6H30.

@docknow .........  I read what you wrote about you putting Herbies Ultra Sonic tube dampers on all the tubes in your Ref 6. Did that include the 6H30 and the 6550 in the power supply? If so did you use the Hal-O 111-9 and the Hal-O - 50 because of the heat with the power supply tubes? 

On the 6550:
(5429748) UltraSonic Rx-50 Damping Instrument     $30.29 X 1 = $30.29

on the 6H30's (# for both REF6 and REF150SE)
(5429716) UltraSonic Rx-9 Damping Instrument     $27.95 X 11 = $307.45