Tubes for Magnepan’s.


I think next up on my acquisition list is a tube amplifier. I'm not looking for the be all end all, cause I don’t think there is a definitive "Best", so am looking for as good as I can get for $3-4k.


Because tubes drive speakers so much more efficiently than solid state I am only looking for 40-50 watts to drive my modded Maggie’s, 1.7i's. (Or what you have when you add a new crossover and planer tweeters to 1.7i's.) Maybe 2.7x? I haven’t settled on that yet. And I have some Zu Dirty Weekend's upgraded to the max coming in in 2 months to replace my KEF's.

Anyway, I haven’t had a tube device since my Halicrafter short wave radio, and reviews are not the same as advice from people that own something. There is a Rouge Audio dealer in my area, last I looked, (opps, they no longer carry them), so I may have to go to another market to hear something, or get a try before you buy from a manufacturer or dealer.

You folks have taught me a lot, and I think asking users is the right thing to do on this change in direction.

Thanks in advance.
128x128william53b
Tube Amps; I have Two Dynaco 60 watts tube Amps push/pull KT88 outputs tubes. what is the value of these Amps ? can anyone tell me.thank you
OP: I have been using the Doge 9 mono block with Doge 8 pre to drive my Magnepan 1,7s for the past five years in my living room system. I am pretty happy with the setup and could certainly recommend it. Doge 9 uses a pair of 211 with a pair of EL34 and four 12AT7 tubes in push-pull configuration producing 70 W in class A and 130 W class A/B. I listen to classical, vocal and some jazz and I felt that the power that Doge 9 provided is pretty sufficient to drive the 1.7s to a very satisfying level.  

Doge is a small Chinese company but they do factory direct order to US. My Doge 9s were shipped to my home in US within a week as I remember. Their tech service was sufficient and I've had email exchanges with their chief engineer and he always asked his email promptly, althrough with limited English language skills.
I drive my Magnepan MG III a with Primaluna evo 400 poweramp with KT 150 valve. Wonderful. also at high volume.
@drbarney1

Thank you for the info and offer. Not going to be building any new amps for the foreseeable future as I have some rebuilds in the works and am also building some Fostex folded horns this year. But I will put the link and your note in my project file.

As of today I am waiting for some new crossover parts for some ideas I have for my 1.7i’s, everything should be here by Wed. of this week, so it’s back to my wife’s garden for me until they get here.