Two Amplifiers Connected in Parallel?

Thanks everyone for the replies. Comments so far leave me on the fence regarding this. I don't have much experience in this sort of thing but intuitively, somewhat makes sense.

If I do try this, here is will do:

Equipment: Pioneer Elite VSX-32 Preamp/Receiver, Two Rega Maia amps, R & L Spendor SP7/1 speakers

Single line L and R outputs from the preamp and connect to L and R inputs on amp1. Use amp1 L and R link outputs and connect to amp2 L and R inputs. This is the parallel connection.

Amp1 R speaker outputs to R speaker tweeter, amp1 L speaker outputs to L speaker tweeter.

Amp2 R speaker outputs to R speaker mid/bass, amp2 L speaker outputs to L speaker mid/bass.

Make sense?

Stevensctt
I am not familiar with the Spendors,so assuming that they are bi-wire capable,that is they provide TWO inputs at the back ,then remove the bridging straps.Your connection seems wright.
If you want go to youtube and search for "virtualdynamics" "QnA bi-amping" there you can find a 10 minute tutorial from Rick who explains it further.
Regards
George

Thanks again for all of the replies.

Elizabeth, I do fall into this group: "usally asked by folks who know very little about it, except it 'sound' (inthier hhead at least) exciting and sophisticated"

Yioryos -- Thanks for the virtualdynamics video on youtube. Most of the discussion involves vertical bi-amping but after viewing I'm not sure why vertical or horizontal bi-amping really should ever be considered. It seems that monoblock amps are the only consideration if using two amps in a 2CH set-up.

I've decided against the horizontal bi-amp idea.

Stevensctt
Can the Rega Maia amps be bridged into mono? For example my Mark Levinson 27.5 was designed to be bridged and it says so in the manual ,it does require a special cable to complete the switch and of course a second ML 27.5 to be used to drive the other channel.A while back I looked for a used 9/10 or better condition ML 27.5 in Audiogon to buy,I wasn't satisfied with the condition of the ones I found,except one that was truly mint but priced very high and the seller was difficult so I passed,and I do regret it now.
All the other Rogue gear I used in my bi-amping set-up I own and have at home so I could play around.I am hoping to perhaps buy an external crossover such as the Bryston 10b (usually goes for $1000) and get same cabling for all connections and give it a second try.
Best regards
George