2. tech-talk
  3. 1091797018

Voltage conversion from 220V to 110V.

With all the deals you see on Euro and Asian market stuff that operates on 220V its hard not to wonder is there a problem using a North American converter.

Ive got my eye on a set of Asian market mono bolck tube amps. Theyre the 220V version but theyre also about $1500 cheaper than their North American counterparts.

Can I expect any sonic problem stepping the voltage up for their requirements with a high quality converter?

What kind of converter would work best?

Thanks.
nm512
hepl
147 posts
 
As stated above 220V is cleaner(less noise) than 110V.
The 220V lines are balanced and each of the two hot lines cancel the other one noise. My system was changed(Linn) was
changed from to 110V to 220V, by means of a switch at the back of each unit, I highly recommend the voltage change.
The sound improvement was noticeable. Hector.
Post removed 
nm512 OP
8 posts
 
Heres the specs from the unit as per their website......I dont see where it mentions the cycle. These are tube mono blocks. I would end up running a seperate line just for the amps because the rest of my system is 100V.

Output: 50W x 2
Output impedance: 4 Ohms, 8 Ohms
Distortion: <= 1%
Frequency Response: 18Hz-30KHz +/- 0.5db
S/N: >=95db
Input Sensitivity: 550mv
Tube types: EL34 x2/ 6N8P (6SN7) x1/ 6N9P (6SL7) x1
Measurements: 460 x 204 x 188 mm
Weight: 16 Kg x2 (gross weight: 19 kg x2)
Power supply: 220-230V

I dont think there is something as simple as a switch or pin the change it otherwise the seller would mention how easy it is to switch since this seems to be affecting his selling price.
Post removed 
eldartford
4,262 posts
 
Jea48...The "neutral" (white) wire in our 110 volt system is connected to ground only back at the fuse/breaker box. In the electronic equipment the input power goes only to the transformer primary winding which is floating (not connected to ground).

There might be a pilot light needing replacement or a dropping resistor. A schematic would help, but I doubt that you would have much of a problem making the conversion.
More to discover