2. analog
  3. 1350320370

VPI Platter Spinning SLOWLY

I've tried two different lubricants (Super Lube and Shimano Dura Ace Grease) for my VPI Classic 2 platter and it still does not spin properly. I removed and re-applied grease and it spins fine for about 5 minutes, then it slows down immensely. If I remove/re-install the platter, it spins smoothly again but only for a short period of time. Anyone experience this before and know a fix? Thanks
jyoungpark
pbnaudio's avatar
pbnaudio
1,613 posts
 
Have you cleaned out the female part of the bearing as well, grease can get stuck between the two bronze sleeves there. From your description it sounds like you have too much grease. I use Viper Lube by Locktite item # 36784

Best of luck

Peter
brf
1,715 posts
 
You do not need to lube the shaft, the bearing inserts are made out of self lubricating material.
philb7777
401 posts
 
Check plastic pulley on the motor. There should be a small Allen wrench site on the side. Make sure it is tight.
jyoungpark OP
17 posts
 
@Pbnaudio
What is your method for pulling the bearing out to access the well?

Thank you all for the suggestions.
bpoletti
1,552 posts
 
Belt slipping?
More to discover