2. analog
  3. 1224968450

VPI tone arm set up

Wanting to get back into analog, I just completed all my purchases (here on Audiogon) and am ready to start putting everything together. I have a VPI Aries 1 turntable, a VPI JMW 9 Sig. tonearm and a Shelter 501 mk11 cartridge I have mounted to a Cartridge Man Isolator. My question is- I understand the distance between the spindle and tone arm pivot is to be 223mm. Are they talking about center of turntable spindle to center of tonearm pivot? Also, I purchsed a VPI tonearm jig and noticed it only has 1 null point (inner, closest to turntable spindle) where as other jigs I've seen have 2 null points. Will this align correctly?
markpao
kenmra150
1 posts
 
Hi Mark,

I believe that your assumption is correct on the 223 mm spacing. I have the same tonearm on a Scoutmaster, which uses a similar jig. VPI cartridge alignment is done at one null point, which is slightly different than most traditional tone arm set ups. Fremer's DVD on turntable set up has a section specific to VPI tables if you want a decent reference. Your set up will sound really nice when you get it dialed in.
mm2550
16 posts
 
I have a Scout and the Shelter 501 cartridge. Apparently, the combination is controversial to some on these boards, although I think it sounds good. The dealer added some weights to the cartridge to make the combo work better. By the way, I'm an amateur, but since you have the same cartridge, I thought I would just call this issue to your attention.
stanwal's avatar
stanwal
3,147 posts
 
If you look on Vinyl Engine there is an exhaustive study of VPI arm geometry. It exhausted me and I'm a VPI dealer. But it is worth a look. The design of many of the moving coils is not greatly changed from the days when tone arms were typically of much higher mass and with lower mass arms the resonance frequency of the cartridge-arm combination will be too high. Thus the weights to raise the arm mass.
More to discover