WA-Quantum GmbH's Quantum Chips

Ozzy, hmm, serendipity at work. What I actually said was that I put a Power Chip on my power strip at the point that the power cord attaches. My system is out of service for a while as it is my grand daughters' bedroom and will be for seven days.

On a related matter, I finally found a spot on my power panel where the second Power Chip gives an improvement. Since my two dedicated lines were installed last, they are at the bottom of my panel. I scotch taped the Power Chip where the breakers are.

Several questions:
1. Has anyone tried a chip on the side of an outlet either in the wall or in a power strip?
2. If one were to try 2 or 3 chips only, which would be most advantageous?

Rja, I have a fuse chip on my each of my 3 dedicated circuit outlets, works great there.
For sure the fuse chips are a great starter chip, then I would say the power chip, followed by the large cap chips (if your amp has some large caps).

Ozzy... Where-in you say you "placed the power chip on the iEC just before my Audience Conditioner"... are you saying you placed the power chip on the PowerCon conector?

Well, I actually have 3 of the Audience aR2p-TO units.
But yes, apply it before it goes into the Audience unit. Perhaps even on the Audience unit itself would also be ok but I was a little concerned about attaching something stickey to it.