Wall Mounting Hardware for Acoustic Panels


Does anyone have suggestions for suspending absorptive panels from the wall, and also from a slanted ceiling? I am constructing my own panels from Owens Corning 703 (rigid fiberglass) set within wooden frames and covered with cotton cloth. I need to find some good hardware to mount them on the wall. I've heard some mention of velcro, but don't fully trust it unless I were to hot blue the receiving side onto strips of wood and screw the wood into the wall. Has anyone hung panels to recommend some hardware alternatives?

Thanks, Peter S.
peter_s
For vertical walls plain old picture hangers work fine. You can tack the bottoms with velcro or blue tack to prevent vibration or movement. For a slanted wall you might try slotted hanging hardware-the little plates with a large hole that tapers to a slightly narrower slot so you can put a screw head through the hole and then slide the object to be hung so the screw heads goes into the slot. Know the type I mean?
Hi
I just bought a # of panels from RPG, and the came with what they call impaling clips. Basically they are about 4" square flat plates with a # of protruding spikes at 45 degree angles. First you screw them into the wall. Then after determining the desired height, you place the panel one inch above that height. By pressing in and down, the panel is held securely against the wall, perfectly flush. They work brilliantly. If you go to RPG's web site, you can find more info.
Regards
Carl
Thanks Carl,

Here is a link to the impailing clips, although I've been told they are probably available at Home Depot.

http://www.acousticalsolutions.com/products/hardware/impaling_clips.asp

How many did you put up per panel? How big were your panels?

But here is the ultimate link for panel mounting hardware, with schematics and mail order accessability!

http://www.rockler.com/ecom7/product_group.cfm?&objectgroup_id=74&catid=22